How to put Bluetooth lighting devices into pairing mode?

Light bulb devices and table lamp devices typically enter pairing mode using different methods. Follow the appropriate instructions for your device type.

Light Bulb Devices

Light bulb devices typically enter pairing mode using the following methods:

1. Cycling Operation

Some light bulb devices may require a specific sequence of switch operations to reset. This is usually achieved by executing a series of power on and off cycles within a given period of time (e.g., switching three times).

2. Power Cycle

Turn off the power switch of the light bulb, wait for a few seconds, then turn the power switch back on. Some devices may enter pairing mode when powered back on.

3. Contact Manufacturer Support

If you are unable to reset the device to pairing mode after trying the above methods, it is recommended to contact the customer support of the device manufacturer for further assistance and guidance. They may provide detailed reset steps specific to the device.

Table Lamp Devices

Table lamp devices typically enter pairing mode using the following methods:

1. Power Cycle

Firstly, try unplugging the power plug of the table lamp device, wait for a few seconds, then plug it back in to see if the device enters pairing mode.

2. Press Button

There may be a reset button on the table lamp device. Try pressing and holding it for a few seconds to see if it triggers a reset operation and enters pairing mode.

3. Cycling Operation

Usually achieved by executing a series of power on and off cycles within a given period of time.

4. Refer to Manufacturer's Manual

It is recommended to check the manufacturer's provided manual for specific reset steps for the device. They may provide specific button combinations or sequences for operations.