LogoSmartLife App Docs
LogoSmartLife App Docs
Homepage
Help Center
Device Networking Issues
Router Configuration
Device Network Provisioning Guide
General Q&A on Device Network Provisioning
Bluetooth Provisioning Guide
Wi-Fi Device Network Provisioning
Zigbee Device Network Provisioning
Network Provisioning for Other Protocols/Methods
How to add device by scanning the QR code?How does the camera use the scanning QR code to configure the network?How to set up network for 4G devices?How to control Wi-Fi and Bluetooth dual-mode devices only through Bluetooth?Can Wi-Fi and Bluetooth dual-mode devices be added at the same time with two communication methods?How does the device use the cable mode to connect internet?NB-IoT Device Connection MethodsHow to Set Up Network for NB Devices?How to get the network pairing code for matter devices in the "Home" App
Device Connection Failure
Device Offline
App Use Issues
Home, Members & Room Management
Device Management and Control
Value-added Services & Extended Functions
Third-party Control Issues
Device Network Provisioning Guide
Frequently Asked Questions
Manwal ng Gumagamit
Help CenterDevice Networking IssuesDevice Network Provisioning GuideNetwork Provisioning for Other Protocols/Methods

How to control Wi-Fi and Bluetooth dual-mode devices only through Bluetooth?

Learn how to control Wi-Fi and Bluetooth dual-mode devices using only Bluetooth connection.

Dear user. The steps to control Wi-Fi and Bluetooth dual-mode devices only via Bluetooth are as follows:

Prerequisites

Make sure your mobile phone has turned on the Bluetooth switch before proceeding with the configuration.

Step-by-Step Guide

Step 1: Re-configure Your Device

You need to use the Bluetooth pairing method to re-configure your device.

The mobile phone needs to be connected to WiFi during the pairing process, as the cloud needs to verify the device. This WiFi connection is only required for the first pairing.

Step 2: Disconnect from Network

  1. Power off the router used during network configuration
    • If you are using a mobile phone hotspot to pair the device, turn off the mobile phone hotspot instead
  2. Turn off the mobile phone Wi-Fi switch
  3. Only turn on the 4G and Bluetooth switches
  4. Wait for about 3-5 minutes

Step 3: Automatic Switch to Bluetooth Mode

After about 3-5 minutes, the dual-mode module will automatically switch to the Bluetooth control mode because it disconnects from the WAN.

At this time, you will still be able to control the Wi-Fi and Bluetooth dual-mode device through the Bluetooth of your mobile phone.

Summary

By following these steps, your dual-mode device will operate in Bluetooth-only mode, allowing you to control it without requiring a Wi-Fi connection.

Talaan ng mga Nilalaman

Prerequisites
Step-by-Step Guide
Step 1: Re-configure Your Device
Step 2: Disconnect from Network
Step 3: Automatic Switch to Bluetooth Mode
Summary